2004.5-2007 DODGE 5.9L CUMMINS DIESEL REMAN INJECTOR (325HP) SET WITH 6 CUMMINS FEED TUBES
REMAN CUMMINS 5.9L DIESEL FUEL INJECTOR USING BRAND NEW COMPONENTS.COMPLETE REPLACEMENT OF NEW BOSCH NOZZLE AND CONTROL VALVE ASSEMBLY EACH INJECTOR INCLUDES ALL NEW O-RINGS & COPPER CRUSH WASHERS. ALSO INCLUDES 6 CUMMINS FUEL FEED TUBES
Does your Dodge Ram have over 80k and have a hard start? Maybe it doesn't start at all? Maybe it misses or makes a funny ticking sound? These injectors may be what you need.
Dodge puts 10 micron fuel filters in the Cummins motor of you truck. Your injectors need a 2 micron filter to keep all of the gunk in your fuel out of them. Many people do not even get to 50k miles before they have a problem caused by fuel contamination.
Another common problem for these injectors are cracks caused by a rail pressure box. If you are using an aftermarket power enhancement and it plugs into the rail pressure, chances are its a pressure box. There are very few rail pressure boxes that are a small enough amount of pressure to be safe, so use them at your own risk. Even some downloaders have the ability to raise pressure
Injector Type: Bosch common-rail injectors
Flow Rate: Approximately 25-30 liters per hour (lph) at 160 MPa (megapascal)
Fuel Pressure: Up to 26,000 psi (1,800 bar)
Actuation Method: Solenoid
Control Method: Electronic signals from the Engine Control Module (ECM)
***Bosch recommends replacing feed tube when replacing all injectors for the best fuel economy and performance. Reusing old feed tubes will lead to leaks, contamination and premature injector failure***
OEM NUMBER:
0986435503, 0445120210,0445120113, 0445120018, 0445120255, 4940589NX, R8004082AA, DT590001R, 3949913, 4940589, 3949619, 3947550, 5254686, 5263318, R5086894, R80040821
Mopar Part # - 5086874AB, 5175565AA, 6800533AA
Cummins - 3979419, 4929865
Bosch Part# - F 00R J01 572, F 00R C00 647, F 00R J01 831
Install Specs:
Injector: Pre-torque hold-down bolt to 44 inch-pounds to ensure injector is seated & centered.
Feed tube: Pre-torque to 11 ft-lbs. to ensure feed tube is seated & centered.
Injector hold-down bolts final install: 89 inch-lbs.
Feed tube final install: 34 ft-lbs.
Rocker Arm mounting bolts: 27 ft-lbs.
Wire connector nuts final install: 13 inch-pounds. DO NOT OVER TORQUE!
Feed tube lines: Torque at 22 ft-lbs.
**LIMITED 1-YEAR WARRANTY
**FUEL SYSTEM MUST BE CLEANED AND MUST BE FREE OF ANY FOREIGN CONTAMINANTS. IF ANY CONTAMINANTS ARE PRESENT ON ANY OF THE INJECTORS, THE WARRANTY WILL BECOME VOID**
**⚠California Proposition 65 Warning: Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm.
Visit: www.p65warnings.ca.gov
