2001-2016 GM/CHEVROLET 6.6L DURAMAX LB7 LLY LBZ LMM LML HIGH QUALITY CYLINDER HEAD STUD KIT - AFTERMARKET 230-4201A
If you want to grab great quality cylinder head studs and you want to save a little bit of $$$, Big Dawg Diesel has got you covered!! These head studs are rated at 220,000 psi tensile strength to cylinder heads from lifting due to high combustion pressure and provide maximum durability for your GM 6.6L Duramax Diesel trucks. It covers truck model LB7 to LML (2001-2016).
Fits all 2001-2016 GM/Chevy 6.6L Duramax Diesel Engines
DESCRIPTION:
- 220,000 PSI TENSILE STRENGTH
- THREADS ROLLED AFTER HEAT TREATMENT
- CHROMOLY 12 POINT NUTS & PARALLEL GROUND WASHERS
- HEAVY DUTY STUDS FOR YOUR HEAVY DUTY DIESEL APPLICATION
Installation Method for Head Stud Kit
Part Number - 230-4201 Application - GM 6.6L Duramax Diesel
- Clean and inspect all hardware prior to installation. Look for obvious defects or shipping damages, plus proper fit, length and dimension.
- To ensure proper thread engagement and accurate torque readings, clean ALL threads in the block. Use a thread chaser or thread cleaning tap for both M12 X 1.5 andM8 X 1.25.
- If the cylinder head studs protrude into a water jacket, lubricate the block threads of the studs with a thread sealant. This will protect against rust, leaks and loosening from vibration.
- Screw studs into the block “Hand tight ONLY!!” – Note: Loctite may be used IF a PERMANENT MOUNTING of the studs is preferred. The FASTENERS, however, must be torqued PROIR to the Loctite setting up
- Install the cylinder head(s) and check for binding or misalignment.
- Lubricate the stud threads, nuts and washers with high-quality lubricant such as ARP Ultra-Torque Fastener Assembly Lubricant. Do NOT use motor oil as a lubricant!! This is due to higher friction on the studs as well as inconsistencies in the clamping force of the fasteners when motor oil or low quality lubricants are used.
Preload (Torque) Recommendations
Following the manufacturers recommended torque sequence tighten the nuts in three equal steps to the following specifications using high quality lubricant such as ARP Ultra-Torque Fastener Assembly Lubricant.
M12 125 ft. lbs M8 25 ft. lbs
Fits GM Chevy 6.6L Duramax Diesel Trucks - LB7(2001-2004) LLY(2004.5-2005) LBZ(2006-2007) LMM(2007.5-2010) LML(2011-2016)
NOTE: Tested at 220,000 Tensile Strength
**⚠California Proposition 65 Warning: Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm.
Visit: www.p65warnings.ca.gov
